Xinzuo 7.3" Santoku
A newly designed Santoku combining 67 layers of Damascus steel with a comfortable ebony handle for effortless slicing.
Pros
- +Updated design
- +Solid balance
- +High-end feel
Cons
- −Handle is small
- −Pricey for Santoku
Full review
Design
The Xinzuo 7.3" Santoku Damascus is built around 67-layer damascus 10cr15comov at 60-62 HRC, paired with a ebony wood handle. A newly designed Santoku combining 67 layers of Damascus steel with a comfortable ebony handle for effortless slicing. The blade profile is a proper santoku — tall and flat for clean push cuts on the board.
Edge retention
67-layer Damascus 10Cr15CoMoV run at 60-62 HRC is a sensible target for this style of knife — hard enough to hold a fine edge through weeks of use, forgiving enough to touch up on a ceramic rod or 1000/6000 stone without micro-chipping. Expect a strop every couple of weeks with daily use and a full stone session every few months.
Ergonomics
The ebony wood handle is comfortable in either hand, with a balance point that sits right around the bolster for a neutral pinch grip. The spine and choil are eased so long prep sessions don't leave hot spots, and the 7.3" blade length is a solid all-round choice for the santoku format.
Value
At around $88 shipped, this competes with mid-tier Japanese-branded santokus that cost roughly double, and the fit and finish holds up to the comparison. You're paying for the steel, the cladding, and a real ebony wood handle — not a stamped blade with a plastic grip. As with most factory grinds in this bracket, a short session on a stone taking the edge down to a finer angle makes it noticeably sharper.
Specifications
| Brand | Xinzuo |
|---|---|
| Type | Santoku |
| Blade Material | 67-layer Damascus 10Cr15CoMoV |
| Core Hardness | 60-62 HRC |
| Blade Length | 7.3" |
| Handle Material | Ebony wood |
| Edge Angle | 15° per side |
| Origin | Mainland China |
| Price | $88 |
A refined version of a kitchen staple that performs as well as it looks.
Buy on AliExpress
